Installation is quite simple, you simply route the Fibers to where you want them before placing the decking planks in their final position,. Towards the botom left of the photo you can see one of the Fibers underneath the timber.

You then drill the planks and feed the Fiber into the pre-driled holes before laying the planks flat and fixing down.

The decking shown here has no end caps because it gives a much neater appearance and the Fibers are virtually invisible when switched off.

It is best to fit the Fibers to the raised part of the plank not the routed section as this keeps the Fibers from being covered by debris such as leaves and grit.