Dimensions: 120mm x 110mm x 45mm

The ICELED DMX Bridge allows any of the ICELED Products (including our colour changing LED Tape, Modules, and Bars) to be controlled via a DMX Controller.

Normally every DMX512 light source has to have its own 9-bit channel address that parks it at one of the 512 possible addresses.

The ICELED bridge only needs one address to base four light sources from and can supply both power and data down one simple cable to each light source.

This DMX512 Bridge serves as a distribution point for both power and data – greatly simplifying the task of installing and addressing multiple light sources.

Four independent zones of control are available occupying a total of 12 sequential DMX channel addresses.

Each zone is assigned three DMX channels to provide separate control over the individual colour components. For maximum programming flexibility one of two different colour models can be selected using a DIP switch:

“Red, Green, Blue” or “Hue, Saturation, Brightness”.

Specifications:

Nominal supply voltage: 12 Volts DC (1)
Standby current drain: 0.02 Amps (all channels zero)
Maximum load current: 10 Amps
Data input: DMX512
Dimensions: 120mm x 112mm x 45mm

• Connects to all ICELED light sources including our other RGB Products when used with a Flexidriver
• Can power up to 10A of LED Lighting

ICELED DMX 512 Bridge - £78.00

In-Line* 5A Switch Mode, Mains power supply for above. Will work in the U.K and on Worldwide voltages.

£25.00

The 10A PSUs are supplied at cost price and are not for sale separately.