Mini LED Screw Lights - Pack (10)
Mini LED Screw Lights are ideal for where a pin point of light is required either to highlight an object or for effect.
Use in places such as railings, ceilings, steps and stairs.
It is possible to use the Mini LED Screw Lights anywhere a bolt can be fitted, just drill a hole and fix them into place using the screw thread and nuts and washers supplied, tighten with a small spanner, then connect the two wires and power them up.
They use very little power just 0.25 watts per Mini Screw Light!
Each Mini Screw Light is fitted with a Superbright LED and an in-line resistor allowing for direct connection to 12vdc.
They can be used with any 12v dc power supply (Transformer), Vehicle Battery (via a fuse on the + terminal), and can even be powered from a 9v PP3 (Smoke Alarm) battery.
There is approximately 90cm of wire on each Screw Light.
Choice of 8 colours:
- Warm White (Halogen White)
10 Mini LED Screw Lights of the same colour are supplied in a pack, making them one of the lowest cost LED products available in the U.K.
The 2A Plug-top 12vdc Power Supply (Plugs into mains socket) it will power up to 80 Mini LED Screw Lights. (Available below)
Or if you need the Mini LED Screw Lights to be switched on and off via a wall switch then the 1A is recommended (powers up to 40 Mini LED Screw Lights) or 2A In-Line Power Supply is recommended (powers up to 80 Mini LED Screw Lights). (Available below)
The Mini Screw Lights are Dimmable if used with either of the In-Line Dimmers below.
Twin Core (3A) Mains Cable (White) can be used to extend the wire to the Mini LED Screw Lights from the 12v output of the Power Supply or use between the Screw Lights. (Available below)
|LED Type||High Intensity 5mm Dome LED|
|Current||20ma per LED Screw Light|
|Power Consumption||0.24w each|
|Light Output mcd / IF=20mA||Red 4,000 mcd |
Green - 20,000 mcd
Blue - 6,000 mcd
Yellow - 6,000 mcd
Pink - 800 mcd
UV/Purple - 100 mcd
|White - 25,000 mcd |
Warm White - 19,000 mcd
|Length of Wire pre-fitted||90cm|
|Construction||Nickel / Stainless Steel - Non-Rust|
Product Code: MiLEDSL
Automatic Quantity Discount
Towards the bottom of the page you will find a selection of suitable Power Supplies (Transformers), these are needed to run the LED Lights from the mains or a light switch.
For more information about one of the products below simply click the name of the product.
|Electronic Dimmer (8A) - Rotary||£13.50|
|Remote Control Electronic Dimmer (3 Amps)||£12.50|