
Car Accessory Lighting |
![]() |
Flexible LED Chain Resembling a chain from a bicycle this LED Chain is composed of silicone with LED Encapsulated within to make them waterproof. 12vdc Ideal for confined areas or where you want light to go around corners. The Chain is supplied in a 1 Meter length. Available in Blue or Red - £19
|
![]() |
![]() |
||
|
Some wiring is required
|
||
|
|
||
Varad Flashing LEDsThese extremely bright flashing LEDs can be used with or without an alarm system. The LED has approx 2ft of wire for connecting. Available in 8 Vivid Colours: Emerald Green, Blue, Green, Orange, Red, Yellow, White, and Purple Price: £3.95 Each |
||
![]() |
![]() |
|
| Some wiring is required | ||
![]() |
New - 4 Channel Remote Control Virtually the same as the above item but with 4 Channels which allows you to separately control 4 separate items. Remotely control the following; Horns, Ignition, Neons, LEDS, Lighting, Engine Start etc. Also suitable for controlling most of our LED products via a 12v power supply in the home. Operation is via radio frequency so will be unaffected by walls or other obstacles. 12vdc Installation; two wires to the battery, with 8 output wires - 2 for each of the 4 accessories. Fixings and Instructions are included. Price: £29 each
|
|
|
||
Some wiring is required |
||
4 Way Switching SystemThis system allows up to 4 accessories to be controlled through one control box. The pressure sensitive control pad (shown below right) is as thin as a credit card, it is linked to the control box with a ribbon cable (supplied). When one of the buttons is pressed the accessory corresponding to that button stays switched on until the button is pressed again. A must have if you hate wiring, just two wires to connect to the control box - you then connect your accessories to the binding posts on the control box. Instructions included. Relays are built into the controller, each of the 4 relays is rated at 10 Amps (120 Watts), enough for most accessories. Up to 8 items can be connected - 2 items per output. Price for the complete system - £22 |
||
![]() |
||
|
Control Pad - Self Adhesive
|
||
![]() |
![]() |
|||||
![]() |
If you want to get attention then this is the product to have. It is a compact unit which houses 6 blue Strobing LEDs around a white Xenon strobe tube. There are three wires which if connected through 2 switches will allow you to have either the strobe on, the LEDs strobing, or both the LEDs and the Strobe on together. The unit has a built-in adjustable bracket allowing various angles. The LEDs strobe in an arcing movement around the lens, it resembles emergency vehicle strobes. The strobe tube flashes approximately 1.5 times every second. Suitable for use inside or outside, and is ideal for: ICE installations, under bumpers, wheel arches, motorbikes, Modded PC's etc. This product will work from any 12v dc power supply. Self-tapping screws are included.
This product should not to be used whilst driving on public roads. |
||||
![]() |
|||||
Please click over pictures to enlarge |
|||||
|
Suitable for use with or without an alarm system, these LEDs can transform the look of your headlamps. They can be wired to flash or to stay "on" with or without an alarm system. Available in 5 colours: White, Aqua, Orange, Green, and Purple
Pack (2) Headlight Tint/Flashers - On Sale £8.95
|
||
![]() |
|||
![]() |
Car Accessory Adaptor |
![]() |
A plug-in mains adaptor with a built in lighter socket allowing any of our 12v car accessories with lighter plugs fitted to be powered from the mains. British Standard (BS1363) approved. For use in U.K homes only. Power 12w, Output 12v, 800mA. Price each: £7 |
||
No wiring necessary |
||
|
U.K Postage - £3 per order
|
|
|
Europe Shipping - £7 per
order
|
USA & Rest of World Shipping
- £9 per order
|
|
Disclaimer: The Litewave Company cannot
be held responsible for any damage that may result of you modding your
car
|
|
|
©
Copyright The Litewave Company
|