Supplier of Litewave ® Professional LED Strip since 2012. 6 Year Warranty. Buy with confidence. Email or phone for a free quote

Fitting guide for Cabinet Hinge Lights

The Cabinet Hinge Light is very easy to fit, an should not take more than a few minutes to do.

Parts identifier   Cabinet Hinge Light Parts  
Step  1  

PLEASE NOTE: The Hinge should already be fitted to the cabinet before fitting the Hinge Light.

Remove the screw from the hinge of the cabinet, this needs to be screw towards the back of the hinge (as shown) not the door alignment screw.

Remove the screw from the hinge of the cabinet
Step 2   Fit the back plate for the Hinge Light onto the hinge and return the screw into position Fit Hinge Light back plate to cabinet hinge
Step 3   Fit screw supplied with Hinge Light into back plate, then tighten screw onto backing  Tighten supplied screw into back plate
Step 4  

To avoid the light shining into your eyes after fitting the battery, we advise applying a small sticker or short length of electrical tape over the LEDs.

Insert the included 12v battery into the hinge light

Insert battery into Hinge Light
Step 5   Clip the Hinge Light onto the back plate, remove the electrical tape or sticker covering the LEDs and avoid looking directly at the LEDs when illumnated. Clip the Hinge Light onto the back plate
Step 6   The LED should light when the switch is depressed (door open) and switch off when the switch is pressed (door closed) Test Light, it should switch on and off when door is open and closed

 

Cabinet Hinge Light illuminating Kitchen Cabinet

toggle